Electus 3D Printer Bed Adhesive Extra Strength NA1102

Completely prevent warping with the new Fialform bed adhesive spray designed specifically for high temp materialsPETG, ABS, ASA, nylon and many more FDM based materials or when you are having issues getting the first layer to print. The part is securely held whilst the plate is warm and automatically pops off when the printer has cooled making it the ideal solution for bed adhesion.Filaform Bed adhesive spray EXTRA STRENGTH has been tested on smooth and textured PEI bed platforms and works very well in both scenarios.

In the world of 3D printing, bed adhesion is a crucial factor that can make or break the success of a print. If your prints aren’t sticking to the bed, you’ll end up with incomplete or distorted prints that are unusable. That’s where Filaform Bed Adhesive Spray Extra Strong comes in. This high-performance bed adhesive is specifically designed to hold your 3D prints in place, even during prolonged printing sessions. Made from a specially formulated blend of polymers, this adhesive creates a strong, durable bond that will keep your prints in place, specifically designed forhigh-temperature filaments.

Applying Filaform Bed Adhesive Spray Extra Strong is easy. Simply shake the bottlewell and spray a thin layer onto your bed. Allow it to dry for a few minutes before printing. It’s suitable for use with a wide range of high-temp 3D printingmaterials, including PETG, ABS, PC, PEEK and carbon fibre nylon. Its versatility makes it an excellent choice for any 3D printing enthusiast looking to improve the quality of their prints.

When it comes to removing your printed parts, Filaform Bed Adhesive Spray Extra Strong makes it easy. Simply allow the bed to cool and your printed parts will self-release without needing a scraper. This feature makes it a breeze to remove your parts and get them ready for post-processing.

Filaform Bed Adhesive Spray Extra Strong is an excellent choice for anyone looking to improve the quality of their 3D prints. Its strong, durable bond and easy application make it a must-have for any 3D printing enthusiast. Order yours today and take the first step towards consistent, high-quality prints every time.

Instructions:

Ensure the print surface is clean Spray thoroughly onto the print base from approximately 10cm ensuring youcover the entire surface Print your model Wait for the platform to cool down (below 30 degrees C) and the part should remove automatically.

Completely prevent warping with the new Filaform Extra Strength bed adhesive spray designed specifically for PLA+, PETG, ABS, ASA, nylon.